Corghi EM 9350 XLine Manuel D'utilisation page 86

with snap-in coupling (E, Fig. 4a);
- Secure the wheel guard by tightening the screw provided (F, Fig. 4a).
Assembly of the ultrasonic sensor and its "optional accessory
supplied on request" support for automatic width measurement
- insert the ultrasonic sensor cable in the slots on the metal pipe (see fig.5);
CAUTION
to facilitate the access of the cable in the slots on the metal tube, it is advisable to
remove the tube from the rotation pin by unscrewing the M12 screw present.
- fasten the ultrasonic sensor support to the
guard pipe using the three screws provided
(fig. 5a);
- connect the sensor cable to the connector
on the side of the casing (A, fig.6)
- Adjust the length of the ultrasonic sensor
cable near the connector (A, fig.6) with a
closed guard, to avoid the deformation of
the connector itself during handling of the
wheel guard.
- Then lock the cable through the supplied
strap (A, fig.5). Any excess cable in the
object will be inserted and locked (by
means of the bases already present) inside
the sensor support. To access inside the
86 Operator's Manual EM 9350 - EM 9350 C XLine
4a
5