Corghi EM 9350 XLine Manuel D'utilisation page 82

Handling and manoeuvring after installation
The machine may be handled and manoeuvred after installation as follows:
• Disconnect the power cable from the socket
• Remove the plug in one of the trays of the weight holder cover
• Screw the eye-bolt supplied completely onto the threaded pin in the hole
• Lift the machine with a hoisting hook suitable for the weight of the machine, applied to
the specific eye-bolt fixed to the machine for lifting as illustrated in figure 2a
• Move the machine as required and set down on the floor
• Detach the hoisting hook from the machine
• Remove the eye-bolt, then refit the plug removed previously from the weight tray cover
2a
CAUTION
When moving the machine, do not use:
- the wheel shaft
- the weight tray
- the display head
as a gripping point.
82 Operator's Manual EM 9350 - EM 9350 C XLine