Corghi EM 9350 XLine Manuel D'utilisation page 108

Note:
- automatic width acquisition is re-enabled only with a new acquisition of the automatic
internal measuring arm;
- if the wheel guard is closed or in the case of a fault of the sensor located on the guard,
the machine will automatic set-up for manual width entry when the internal measuring
arm is moved to the rest position.
A geometric value is displayed, and at the same time the corresponding indicator on the
display lights up.
- Check the values measured and then return the arm to the rest position.
- If an incorrect value has been acquired during the measurement phase, move the arms
to the rest position and then repeat the operation.
IMPORTANT
bear in mind that the wheel's nominal diameter (e.g. 14") refers to the planes
on which the tyre bead rests, which are obviously inside the rim.The val-
ues measured are with reference to external planes and, as a result, are
smaller than the nominal values due to the thickness of the rim itself. The correction
value therefore refers to an average thickness of the rim. This means that the data
measured on wheels with different thicknesses may vary slightly (2 or 3 tenths of an
inch maximum) from the rated values. This is not a lack of accuracy of the measuring
devices, but reflects reality.
If the automatic measuring arm fails to operate, the geometrical data can be entered in
manual mode by following the procedure indicated in the paragraph "entering wheel
dimensions - for models with manual inner sensors (distance and diameter)".
If the inner sensor (diameter and distance) fails to operate
- Use the keypad to enter the wheel geometric data by following the procedure described
below:
- press the
108
key.
Operator's Manual EM 9350 - EM 9350 C XLine