Corghi EM 9350 XLine Manuel D'utilisation page 100

Centring with flanges
Removing the C hub
- Insert the special C key (supplied with the machine) in the slot of the C hub (fig.12);
- Completely unscrew the C hub;
- Mount the flange on the shaft and lock it in place with the two screws (A, fig.13) using the CH
6 wrench.
- Lock the wheel onto the flange as usual.
Assembling the C hub
To reassemble the C hub, proceed as follows:
- Hold down the keyboard key
bring the hub C into the open position; the message A 52 will appear on the display
- insert the split pin (supplied with the machine) in the cylindrical protection bush (B, fig.14)
100
A
for at least 3 seconds to lock the wheel shaft and
Operator's Manual EM 9350 - EM 9350 C XLine
12
13
14