Assembling And Installing; Assembly; Fixing The Sunshield; Cameras Features - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7 Assembling and installing

The assembly and installation must be
performed only by skilled personnel.
This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be
required to take adequate measures.
Only network cameras with specific
technical characteristics can be installed (
7.1.2 Cameras features, page 14).

7.1 Assembly

7.1.1 Fixing the sunshield

Mount the sunshield to the housing with the four
screws and 4+4 washers provided as standard.
Fig. 6
14

7.1.2 Cameras features

The camera must be pre-configured in
order to acquire the IP address via DHCP.
The camera must be pre-configured in
order to interface with the NTP server via
DHCP. If NTP configuration via DHCP is not
possible, set the following static address of
the NTP server: 192.0.0.1.
Only network cameras can be installed in
the unit.
• Only cameras with a 100 baseTx type Ethernet
communication port can be mounted.
• Only cameras powered by a terminal can be
mounted. The Pan & Tilt cannot supply power
directly on the Ethernet cable (Power over
Ethernet).
• The power supply voltage of the camera must be
12Vdc.
• The maximum absorbed current by the camera
must be less than 800mA.
• The communication protocol must be ONVIF,
S profile, protocol. The camera must be pre-
configured in order to communicate via the ONVIF,
S profile, protocol.
• The camera must be operate properly between
-10°C (14°F)/+60°C (140°F).
7.1.3 Assembling the camera and
motorised lenses
The correct device working, in the stated
temperature range, is guaranteed with the
use of camera and lens with temperature
from -10°C up to +60°C.
The customer has to take care of assembling the
camera and lenses.
MNVCUPTMAXIR_1430_EN