Assembly; Fixing The Sunshield; How To Open The Housing; Assembling The Camera And Motorised Lenses - Videotec ULISSE MAXI Manuel D'instructions

7 Assembly

7.1 Fixing the sunshield

Mount the sunshield to the housing with the 4 screws
and 4 washers couples provided.
Fig. 6

7.2 How to open the housing

Loosen the leak-proof screws placed on the sides and
lift the upper part of the housing.
Fig. 7
After installation and wiring, close the
product again.
Fig. 8
First of all tighten the two central screws as
shown in figure.
14
7.3 Assembling the camera and
motorised lenses
The customer has to take care of assembling the
camera and lenses.

7.3.1 Cameras features

The correct operation of the equipment,
within the temperature range indicated, is
guaranteed only if you use camera and lens
with temperature limits equal to at least
-10°C and +60°C.
• The power supply voltage of the camera must be
12Vdc.
• The maximum current absorbed by the camera
must be lower than the value indicated below:
800mA.
• The camera output video signal must be of the
composite type with amplitude 1Vpp (negative
sync).
MNVCUPTMAXB_1511_EN