Installation; Connecting The Cables To The Base - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.2 Installation

Never, under any circumstances, make
any changes or connections that are not
shown in this handbook. Failure to follow
the connection instructions that are given
in the handbook may create serious safety
hazards for people and for the installation.
Do not change the wiring in the product
as it is supplied to you. Failure to follow
this instruction may create serious safety
hazards for people and for the installation,
and will also invalidate the guarantee.
Keep a connection diagram for future
reference.
If using the washer kit, the nozzle support
should be installed before positioning
the pan & tilt and the wiring. For further
explanations see the specific handbook for
the kit.
Fig. 22
MNVCUPTMAXIR_1430_EN

7.2.1 Connecting the cables to the base

Insert the cables into the cable glands and, holding
the base at about 20cm from the support, lock the
cable glands with a torque wrench setting of 5Nm.
The cable glands are suitable for cables with a
diameter between 5 and 10 mm.
Fig. 23
For cables diameter from 3mm to 7mm use
the supplied gaskets.
Fig. 24
19