Dip3 Configuration; Address Configuration; Setting Of The Serial Communication Lines; Dip4 Configuration - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.3.5 DIP3 configuration

When the dip-switch rocker is up it
represents the value 1 (ON). When the
dip-switch rocker is down it represents the
value 0 (OFF).
Fig. 59

7.3.5.1 Address configuration

It is possible to set the pan & tilt address: from 1 to
255. Binary code is used to select the address, using
the dip-switches (17 Address table, page 52).
7.3.5.2 Setting of the serial communication
lines
The product is provided with the following serial
communication lines:
• RS-485: 1 line
• RS-232: 1 line
The serial lines configuration must be carried on
through the following dip-switches:
• DIP 3: SW 9-SW 10
DIP3 CONFIGURATION
SW SW SW Configuration
10 9 8-1
OFF OFF – It allows the one-way communication
on RS-485-1 line. It allows the two-ways
communication on RS-232 line.
ON ON – It allows the two-ways, half-duplex,
communication on RS-485-1 line.
Tab. 10
32

7.3.6 DIP4 configuration

Unlike the previous cases in this table when
the dip-switch rocker is up it represents the
value 0 (OFF) while if the rocker is down it
represents the value 1 (ON).
Fig. 60
DIP4 CONFIGURATION
Description SW 2
Factory default –
–
RS-485-1 line ON
OFF
Tab. 11
SW 1 Configuration
ON Enabled
OFF Disabled
– Terminated
– Not terminated
MNVCUPTMAXIR_1430_EN