Preparatory Work Before Installation; Attaching The Support; Cables Management - Videotec ULISSE MAXI NETCAM Manuel D'instructions

6.4 Preparatory work before
installation

6.4.1 Attaching the support

For installations subject to vibrations, only
use the parapet bracket.
Different types of supports are available (10
Accessories, page 42). Choose the most suitable
installation and follow all indications in this chapter.
Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must
use dowel pins with a traction torque rating
of at least 300dN each. For a metal surface
use screws with a diameter of at least 8mm
and of an appropriate length. The clamping
system must be able to support at least 4
times the weight of the entire equipment,
including P&T, lenses and camera.
The device should be assembled vertically.
Any other position could impair the
performance of the appliance.
Do not attach the device upside down.
MNVCUPTMAXIR_1430_EN

6.4.2 Cables management

The connection cables should not be
accessible from the outside. It is necessary
to fasten the cables securely to the column
in order to prevent excessive weight pulling
them out accidentaly.
You must use cables suited to the type of
installation.
Insert the cables into the support so that they
protrude by about 50cm.
50cm
Fig. 5
50cm
13