Maintaining And Cleaning; Maintaining; Fuses Replacement; Replacing Of The Glass In Case Of Damage - Videotec ULISSE MAXI NETCAM Manuel D'instructions

12 Maintaining and

cleaning

Before doing any technical work on the
device, disconnect the power supply.

12.1 Maintaining

Maintenance must be carried out by
personnel trained to operate on electrical
circuits.

12.1.1 Fuses replacement

Maintenance must be performed with the
power supply disconnected and the circuit-
breaker open.
F2
Fig. 96
44
F1
FUSES REPLACEMENT
Voltage Fuse F1
24Vac, 50/60Hz F 6.3A L 250V 5x20
120Vac, 50/60Hz F 6.3A L 250V 5x20
230Vac, 50/60Hz F 6.3A L 250V 5x20
Tab. 12
12.1.2 Replacing of the glass in case of
damage
Loosen the 5 nuts.
Fig. 97
Extract the external glass plate from the inner one.
Fig. 98
Replace the plate with glass in place of the one
damaged.
Fig. 99
Reassemble the whole set in reverse as compared
with the dismantling and re-tighten the 5 nuts.
Fuse F2
T 8A H 250V 5x20
T 4A H 250V 5x20
T 2A H 250V 5x20
MNVCUPTMAXIR_1430_EN