Fixing The Top Unit; Counterweights Installation - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.2.5 Fixing the top unit

Inside the bottom cover there is a
desiccant bag that is used to prevent
moisture formation in the base and near
the connector boards. Remove the sachet
during installation.
Attach the top unit (01) to the base (02) using the
attachment screws (03), supplied with the seals
(04). Make sure the base seal is present and in good
condition (05).
Pay attention to the fixing. Tightening
torque: 4Nm.
05
Fig. 36
Fig. 37
There is only one way to anchor the base
with the top part. Align the tabs on the
sides to make sure the parts are positioned
correctly.
24
01
02
04

7.2.6 Counterweights installation

Fasten the counterweights to the housing using the
screws and washers supplied.
Fig. 38
Apply a generous amount of thread locking
03
compound into the screw holes (Loctite
243®).
Pay attention to the fixing. Tightening
torque: 16Nm.
MNVCUPTMAXIR_1430_EN