Configuration; Web Interface; First Access - Videotec ULISSE MAXI NETCAM Manuel D'instructions

9 Configuration

9.1 Web interface

During the first connection assign an
address other than 192.168.10.100.
Browsers supported: Microsoft Internet
Explorer, Google Chrome, Mozilla Firefox.
The MAC Address is contained on the label
that is on the CPU board.
Fig. 61
The first operation in configuring the P&T unit
consists in connecting to the web interface.
In the predefined settings for the configured P&T,
to automatically acquire an address through a DHCP
protocol, it is possible to detect the device through
the ONVIF, S profile, protocol.
If no DHCP server is available, the P&T unit will
configure itself automatically with the address
192.168.0.100.
If no VMS is available with the Auto Discovery
functions based on ONVIF, the acquired address can
be read in the DHCP server logs.
To access the Pan & Tilt web interface, simply use a
browser to connect to the address http://ip_address
and log in to Pan & Tilt using the predefined
credentials:
Username: admin
Password: admin
34

9.1.1 First access

For proper operation, the pan & tilt must be
configured in relation to the installed camera.
The required parameters are:
• The IP protocol used to communicate with the
camera.
• The type of installed lenses (motorized, fixed or
integrated).
• The credentials required to connect to the IP
camera (username and password of the installed
camera).
Fig. 62
The IP camera installed in Pan & Tilt must be
configured to acquire the IP address using
the DHCP.
MNVCUPTMAXIR_1430_EN