7.2.11 Closing the housing
Close the housing following the opposite procedure (
7.1.3.1 How to open the housing, page 15).
First of all tighten the two central screws as
shown in figure.
Fig. 52
7.2.12 Fastening of the wiper blade
Insert the blade in the wiper shaft.
Position the blade in the stop position.
Fig. 53
30
Fasten the whole assembly by means of the washer
and nut.
Fig. 54
The correct adjustment must allow the
return of the blade to the stop position
going to the end stop on the casing's plate.
MNVCUPTMAXIR_1430_EN