Led Illuminator Switching On Threshold Adjustment; Led Illuminator Power Adjustment - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.2.10.5 LED illuminator switching on
threshold adjustment
The illuminator on the right must always be
set to maximum brightness.
Switch-on threshold
regulator
Fig. 48
Remove the protective cap, then adjust the activation
threshold with the potentiometer. To increase the
threshold, turn the potentiometer clockwise. To
decrease the threshold, turn the potentiometer anti-
clockwise.
MIN
OFF
Fig. 49
After making the adjustments make sure
that the plug is closed tight to ensure
perfect sealing.
MNVCUPTMAXIR_1430_EN
MAX

7.2.10.6 LED illuminator power adjustment

The illuminator on the right must always be
set to minimum power.
The illuminator is set in the factory to
provide maximum power. If long distances
should not be reached or if the image is
over-exposed for excessive brightness,
decrease the power, so that energy saving is
also obtained.
Fig. 50
Loosen the hermetic plug. Rotate the trimmer,
clockwise to increase the power of the infrared
illuminators and anti-clockwise to decrease it.
MIN POWER
Fig. 51
After the adjustments, ensure that the
blanking plugs are appropriately tightened
to ensure that the product is hermetically
sealed.
Infrared power
control
MAX POWER
29