Led Illuminators Installation; Counterweight Removal; Fitting The Illuminator On The Bracket - Videotec ULISSE MAXI NETCAM Manuel D'instructions

7.2.7 LED illuminators installation

To work properly both illuminators must be
installed together.
From Pan & Tilt, it is only possible to install
VIDEOTEC illuminators.

7.2.7.1 Counterweight removal

Undo the screws and remove the external
counterweights.
Fig. 39

7.2.7.2 Fitting the illuminator on the bracket

To assemble the illuminators, use the front holes on
the counterweight bracket.
Fig. 40
MNVCUPTMAXIR_1430_EN
Place the fixings of the illuminator (01) on those of
the bracket (02).
Fig. 41
Insert the 16mm screws and washers.
Fig. 42
Pay attention to the fixing. Tightening
torque: 6Nm.
02
01
01
02
25