Milk Circuit Cleaning Cycle - Faema BARCODE Traduction Des Instructions D'origine

These procedures are to be performed at the end of the work
day or when the machine sends a message (see paragraph
"Customer programming – Services hour menu).
When the machine sends a message, the screen displays
"EXECUTE WASHING MILK CIRCUIT" accompanied by an
acoustic signal.
The message and signal will continue until the procedure is
performed or up until the end of the timeout (60').
MILK IS A FOOD PRODUCT THAT REQUIRES MAXIMUM
HYGIENE! NOT PERFORMING REGULAR AND DAILY
WASHING CYCLES CAUSES OCCLUSIONS, WHICH
CAN MAKE THE CIRCUIT BREAK AND CAUSE
LEAKS.
Therefore, please scrupulously follow the washing
instructions.
Please follow these instructions for the washing process:
1) After the machine sends the message;
2) Open the door to access the programming keypad;
3) Keep the coffee circuit washing key (28)
the message appears with washing instructions:
Insert milk pipe in
the container with
water and detergent
as per instructions
then
press
4) Place approximately 0.7 liters of cold water in a container
and add a dose of liquid detergent (see product
instructions);
5) Remove the intake tube from the milk container and
immerse it in the solution (water-detergent);
6) Keep the milk circuitt washing key (28)
the message "WASHING IN PROGRESS" appears on the
display:
10 March 2010
wednesday
WASHING IN PROGRESS
00:56
The numbers in the lower part of the display indicate the
remaining time for this procedure;
At the end of this phase, the following message will appear
on the display:
Empty the container
and re-fill it
with fresh water
insert milk pipe
as per instructions
then
press
(Level 1)

MILK CIRCUIT CLEANING CYCLE

Level 1
pressed until
pressed until
15:15:04
1
2
3
4
5
6
61
28