Selection Repetition Function; Coffee Dose Variation - Faema BARCODE Traduction Des Instructions D'origine

This function can be activated in various ways:
1) setting the desired number at the repeats entry in the
beverage recipe (see CLIENT PROGRAMMING and
paragraphs referring to Key Menu). .
Note: To have access to customer programming,the function
must have been previously enabled by the installer "Technician
programming/Configuration/Customer prog. YES".
2) Press any one of the selection keys and after about 3
seconds press the same key again for the number of
dispensed drinks required.
The machine is equpped with a software program that makes
it possible to quickly change the coffee dose without needing
the technician's assistance.
Note: This function is possible ONLY if the entry "bean key",
in the technical configuration menu, has been set to "YES" by
the installer.
To modify the coffee dose, access the programming key (Tp)
and press the "bean" key
on the display:
CUSTOMER PROG.
KEY MENU
Press the key (32) for which you want to vary the coffee dose.
The following will appear on the display:
MM1 cof. dose
-5 064
-
Use the "+" (30) and "-"

SELECTION REPETITION Function

Coffee dose variation

(BK). The following will appear
064
+5
+
(31) keys to set the number.
Note: This second mode can be used only if the "Technician
programming/Configuration/Dispensing Stop: NO" WAS
NOT enabled by the installer.
The number of dispensed drinks programmed is indicated on
the top left of the display. Press the
for about 3 sec. to reset.
NOTE. These functions are deactivated when error messages
and/or codes are displayed and the item "Technician program-
ming/Configuration/Program. block" is set on "YES".
32
The dose set for both grinders in the technician programming
menu can vary by ±5.
Example
Technician programming
Coffee dose MM1 045
Coffee dose MM2 020
To exit the panel, press the key
made to the numbers or press the RES (24) key
the settings as is.
54
key and keep pressed
"Technician program-
Tp
BK
32
Customer programming
Coffee dose MM1 040÷050
Coffee dose MM2 015÷025
to confirm any changes
to leave