Table des Matières
Publicité
English
Other hot beverage
Steam dispensing
Plunge the steam jet pipe (6) into the liquid to be heated in a suitable
container and turn the steam adjustment knob (7).
When the liquid is hot, stop the flow of steam by turning knob (7) the
other way (towards “0”).
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark. Then
plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a few
seconds.
When the required amount of froth has been made and the temperature
is sufficiently high, stop the flow of steam by turning knob (7) the
other way (towards “0”).
When the steam jet pipe (6) is no longer required, clean it thoroughly
with a sponge and a clean cloth.
Dispensing hot water
Position a container under the hot water dispensing pipe (8) and turn
the hot water dispensing knob (9).
When the required amount has been dispensed, stop the flow of hot
water by turning knob (9) the other way (towards “0”).
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
Water level control of boiler
The machine is fitted with a series of automatic level control devices
to keep the water in the boiler at a pre-set level.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control devices
are not working correctly.
Press the filling lever (5), taking care not to exceed the MAX. level on
the boiler water level indicator (13).
9
8
13
English
7
6
5
Publicité
Table des Matières
