Installation Check-Up; Hot Water - Faema BARCODE Traduction Des Instructions D'origine

These chapters in the manual are to be used by qualified, authorized technical staff.

5. Installation Check-up

WARNING: AFTER INSTALLATION, CHECK TO SEE IF THE MACHINE IS WORKING PROPERLY (see the
Installation Module C)
WATER CONNECTIONS
• No leaks from the connections or tubes
FUNCTIONING
• Boiler and operating pressures are normal.
• The pressure gauge is working properly.
• The self-leveling device is working properly.
• The expansion valves are working properly
WARNING: ONCE THE MACHINE HAS BEEN INSTALLED AND IS READY FOR USE, BEFORE ALLOWING THE
WORKER TO START USING THE MACHINE, WASH THE INTERNAL COMPONENTS ACCORDING TO THE
INSTRUCTIONS BELOW:
COFFEE CIRCUIT
• Keep the coffee circuit wash key (

HOT WATER

• Continuously dispense hot water
STEAM (where present)
• Dispense steam from the nozzles for about a minute, using the appropriate buttons.
MILK CIRCUIT
• Keep the milk circuit wash key (
information, please consult the "Cleaning and Maintenance" chapter).
SOLUABLES CIRCUIT (only for machines with solubles)
• Keep the coffee circuit wash key (
mation, please consult the "Cleaning and Maintenance" chapter).
26) pressed for a few seconds and follow the steps indicated on the display.
until at least 0.5 liters of water have been dispensed.
28) pressed for a few seconds and follow the steps indicated on the display (for more
26) and the milk circuit wash key (28)
50
pressed for a few seconds (for more infor-