Installation Check-Up; Hot Water - Faema X20 Guide Rapide

5. Installation Check-up

WARNING: AFTER INSTALLATION, CHECK IF THE MACHINE IS WORKING PROPERLY (see Installation Module C)
WATER CONNECTIONS
• No leaks from the connections or tubes
WARNING: ONCE THE MACHINE HAS BEEN INSTALLED AND IS READY FOR USE,
BEFORE ALLOWING THE WORKER TO START USING THE MACHINE, WASH THE
INTERNAL COMPONENTS ACCORDING TO THE INSTRUCTIONS BELOW:
COFFEE CIRCUIT
• Press the coffee circuit quick wash icon

HOT WATER

• Continuously dispense hot water (using the appropriate button) until at least 0.5 litres of water
have been used.
STEAM (where present)
• Dispense steam from the nozzles for about a minute, using the appropriate buttons.
MILK CIRCUIT (where present)
• Press the milk circuit wash icon
SOLUBLES CIRCUIT (where present)
• Press the soluble circuit wash icon
OPERATION
• Boiler and operating pressures are normal.
• The pressure gauge is working properly.
• The self-levelling device is working
properly.
• The expansion valves are working properly
.
and proceed as indicated on the display.
.
7 EN
.