Cleaning The Appliance; Closing The Appliance - Stiebel Eltron ETW 120 Manuel D'utilisation Et Installation

INsTAllATION
AssEmBlY

10.5 Cleaning the appliance

Clean the appliance after installation and inserting the
storage blocks.
»
For this, remove the air routing assembly.
Undoing and removing air routing assembly
Lift the fan and remove by releasing the screws in the front
retaining brackets. (Observe the cable routing.) With some
appliances, the thermostat – discharge (N5) incl. retaining panel
must be unscrewed.
Risk of damage.
!
When depositing the components you have removed,
ensure that the wires are not damaged.
Undoing screws and lifting out fan
»
Clean the floor plate and fan (do not damage the fins). Then refit
the fan, and if necessary the thermostat and air routing assembly
(ensure cable routing is correct).

10.6 Closing the appliance

»
Hook in the inner front panel with thermal insulation at a slight
angle to the upper edge of the inner cover, and fix to the bottom
with screws.
www.stiebel-eltron.com
Hooking in inner front panel
Hooking in r.h. side panel at the top and bottom
»
Hook in the front panel at the top of the appliance and secure
with three screws (using the inner tapped holes).
Fitting front panel
L-
NN NL
TA LE LH LH LE NN
SH
L-
N N N N N L
TA LE LH LH LE
SH
»
Tighten the air outlet grille with the two three-quarter turn
locks.
Tightening air outlet grille
»
Hook the upper edge of the air inlet grille into the locking device
screws in the air routing assembly, and press from below over
the catch springs.
ETW 120, 180, 240, 300, 360, 420, 480 electronic |
a.
b.
2x
3x
2x 2x
ENN NNN L L-
TAL E`LH LH`L SH
L-
ENN NNN L
TAL E`LH LH`L SH
35