Stiebel Eltron ETW 120 Manuel D'utilisation Et Installation page 33

INsTAllATION
AssEmBlY
»
Slightly lift the r.h. side panel and remove.
Slightly lifting the r.h. side panel and removing
»
Route the power supply cables and connecting cables for the
charge and discharge controllers through the entry in the
appliance back panel into the appliance and connect. Remove
approx. 260 mm of insulation from the connecting cables and
trim as required. The cables must not be placed next to the air
slot in the side panel.
Inserting cables
www.stiebel-eltron.com
»
Secure the appliance according to specification to the floor or
wall (see chapter "Installation location" and "Specification").
Securing the wall retainers
L-
NN NN NL
TA LE` LH LH` LE
SH
L-
NN NN NL
TA LE` LH LH` LE SH
Hooking the appliances into the wall retainers
ETW 120, 180, 240, 300, 360, 420, 480 electronic | 33