Cleaning The Appliance - Stiebel Eltron ETS 200 Plus Utilisation Et Installation

INSTALLATIoN
Installation
f Remove the cover panel and cardboard inserts from the inte- f
rior of the appliance.
The storage blocks are delivered in separate packaging. Storage
blocks with slight transport damage can be used. This does not
impair the function of the appliance.
1
2
1 Heating element
2 Storage block
f To insert the storage blocks, raise the heating elements f
slightly.
f When raising the heating elements, ensure the through f
holes in the side insulation are not widened by the heating
elements.
f Insert the first storage block, with the heating element cavity f
pointing upwards, with some clearance to the r.h. thermal
insulation.
f Push the storage block up against the r.h. and back thermal f
insulation. The long holes form the heating ducts.
f Insert the other storage blocks in the order shown. f
f Push the cover panel taken from the interior of the appliance f
over the upper storage blocks.
www.stiebel-eltron.com

12.7 Cleaning the appliance

f Clean the appliance after installation and inserting the stor- f
age blocks. For this, proceed as follows:
f Remove the air routing assembly. f
1
1 Protective temperature controller (N5)
f Lift the fan out. To do this, loosen the screws located at the f
front on the retaining brackets.
f Observe the cable routing. f
With some appliances, the protective temperature controller (N5)
incl. retaining bracket must be unscrewed.
Material losses
When depositing the components you have removed,
ensure that the wires are not damaged.
f Clean the floor plate and fan. Make sure not to damage the f
fins.
f Then refit the fan, and if necessary the protective tempera- f
ture controller and air routing assembly.
f Observe the correct cable routing. f
ETS 200-700 Plus | 41