Dismounting The Appliance; Power Supply; Terminal Block; Troubleshooting - Stiebel Eltron CNS 50-2 E Mode D'emploi Et Manuel D'installation

INSTALLATION

TROUBLESHOOTING

1
1 Appliance
2 Safety cap
3 Locking bolt

11.3 Dismounting the appliance

Remove the safety cap from the locking bolt.
»
1
1 Appliance
2 Safety cap
3 Locking bolt
Undo the locking bolt on the wall mounting bracket.
»
Lift the appliance up slightly and pull it forwards and away from
»
the wall mounting bracket.

11.4 Power supply

Ensure the on-site supply cable has an adequate cross-section.
»
Ensure a socket or junction box for a permanent power supply
»
is installed at a distance of at least 4˝ / 10 cm from the side of
the appliance.

11.5 Terminal block

We recommend using stranded wire to connect to the terminal
block. Crimp a ferrule over stranded bare wire to ensure a good
connection.
Consult the chart below for the recommended torque amounts on
the terminal block screws.
Screw Diameter (mm) Torque (N•cm) Torque (lbf•in)
2.8 30-40
2.8-3 35-50
3-3.2 50-60
3.2-3.6 60-80
3.6-4.1 90-120
4.1-4.7 120-180
4.7-5.3 150-200
Using the proper torque specifications to secure wire to the wiring
block helps to avoid personal loss or property damage.
See 14, "Specifications", pg. 9 for information on the proper
wire gauge size.
8 |CNS E / CNS 24H
2
3
2
3
2.65-3.54
3.09-4.42
4.42-5.31
5.31-7.08
7.96-10.62
10.62-15.93
13.27-17.7
DANGER: Electrocution
Carry out all electrical connection and installation
work in accordance with all national, state and local
building code.
DANGER: Electrocution
Each heater must be wired directly to the circuit
breaker panel with the proper size breaker and wire
gauge.
DANGER: Electrocution
Do not plug the heater into a wall outlet.
The specified voltage on the nameplate must match
the voltage at the circuit breaker panel.
12. Troubleshooting
The power cable must only be replaced by a contractor using our
original spare parts.
If you cannot remedy the fault, notify the contractor who
installed the appliance. To facilitate and speed up your
enquiry, please provide the serial number from the type plate
(000000-0000-000000).

13. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety information. Hand the operating and
installation instructions to the user.
WWW.STIEBEL-ELTRON-USA.COM