Running System; Clutch Control Line - Mash Side 400 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.

Running system

Tire specifications and tire pressure
Check the tire pressure with a tire pressure gauge to see
whether the pressure conforms to the recommended value.
Tire specifications and recommended tire pressure:
If the tire pressure can't reach the specified requirements,
check the tire for cuts, embedded iron nail or other sharp articles.
Front wheel tire pressure
Caution
The tire pressure measured when the tire is cooled down
shall be the correct tire pressure.
Spoke
Check the wheel for loosened or broken spokes.
Screw the loosened spokes to the specified torque with a
spoke nut fastening tool. The spoke nut torque: 2.45-4.9N.m.
If any spoke is broken or cracked, replace it as soon as
possible.
Rear wheel tire pressure
Spoke nut fastening tool

10. Clutch control line

Check the clutch operating handle free stroke. Clutch
operating handle free stroke: 10-20mm.
10-20mm
Adjusting methods:
Fine adjustment: Pull open the rubber lagging, unscrew the
retaining nut, and turn the adjusting nut to adjust to a satisfied free
stroke. And then screw up the retaining nut and mount the
protective rubber lagging.
37

Publicité

Chapitres

Table des Matières
loading

Table des Matières