Brake System - Mash Side 400 Mode D'emploi

8.

Brake system

The front brake and the rear brake and the side brake is disk
type, due to the abrasion of the brake shoes, the brake fluid will be
getting less as time goes by.
The performance can't be adjusted, but the brake fluid level
and brake shoe abrasion are the two most important factors, that
need to be checked on time.
The brake system should be checked frequently, to ensure
there is no leaking.
Front Brake
Good and bad of brake function concern the move ment
security，that adjust the brake correctly is very important．
Check the front brake handle free stroke.
The brake handle free stroke 10-20mm
10 – 20mm
Warning
brake fluid will arouse inflammation , should avoid being
touched with skin & eyes. Once touched, should clean clearly
with water, furthermore, if touched with eyes, must go to
hospital.
storing in the area where child cannot touch.
Brake fluid level inspection:
Check the brake fluid level in the front brake cylinder: if the
level is too low but not emptied, directly refill brake fluid (DOT 4
brake fluid).
If the brake fluid inside the cylinder is found cloudy, impure or
smelt, Drain and refill the brake fluid.
If the brake fluid in both the front and the rear cylinders is
drained, bleed air from the deflating valve of the brake caliper with a
vacuum pump, and then refill brake fluid into the cylinder. This
model has total of 3 brake calipers, wherein, the rear brake caliper
interlocks with the side brake rear caliper (controlled by rear brake
pedal), therefore, the vacuuming process shall be carried out
simultaneously for the front brake caliper and side brake front
caliper and for the rear brake caliper and the side brake rear caliper.
34