Operation - Mash Side 400 Mode D'emploi

5、Brake system checking, to see if the brake system is
working normally. Brake fluid amount and the state of the brake
shoe should be checked. The brake fluid checking should be
done before the engine started, if the level of the fluid is lower
than the minimum level line, the cause maybe leaking or the
abrasion of the brake shoe. To avoid the utter incompetence of
the brake system. Please go to SHINERAY's technician for
professional inspection and suggestions, we will also help you to
check the condition of the brake pipe, disk and brake shoe, also
the distance of the brake lever and pedal.
6、Cable checking, Please check if all the cable for control
is correctly installed, and moves smoothly.
7、 Throttle checking, check the throttle grip, throttle cable to
see if there is enough gap, and if the acceleration process is
smooth, and turning off process is fast and clear.
8、Clutch checking, the cable should have enough gap to
move, and can move smoothly.
9、Lights and horn checking, please kindly check if the
illumination and the horn are working normally.
10、Rear view mirror checking, sit on the vehicle and keep
your body vertical to the ground, see if you get a clear view of the
world behind you from the rear view mirror.
11、 Steering bar adjusting, sit vertically on the seat, check if
the steering bar is at the best position for your safe and comfortable
operation, also without the tangle of cables..
Caution
When you check, please make sure your conformity to the
safety rules and law.
The exhaustion contains harmful gas, like CO, so please
make sure when you make the checking with the engine started,
and keep it in ventilated place.
The checking should be launched in flat and hard ground,
with stable support.
Watch out for fire when the engine is just switched off,
because the engine and muffler are still quite hot then.
Before you repair or mend, the engine should be switched
off and the key should be pulled out.
If the problems still exist after calibration, please
immediately get contact with our authorized workshops, dealers
or appointed repair shops.

Operation

•Shift the gear properly according to the motor speed,
•In order to keep the fuel consumption at a lower state, and
also to ensure the longevity, please do not accelerate or decelerate
too drastically。
22