Mash Side 400 Mode D'emploi page 24

A. Engine without run-in and the one have been run in have
big difference in their power and torque performance.
B. The well run-in engine: the initial wear-out of the parts is
well renewed, which eases the damage to the parts in fierce
movements, and extend the service life of the engine.
C. Requirements
1). Never fully open the throttle when the new motorcycle
has not been ridden for more than 350km.
2). When riding in each gear, the speed should less than
80% of its allowed speed (the opening of the throttle should be
less than 80%), and shift the gear in time.
3). Do not let your engine bear too much load in the first
350km.
Maintenance of the engine:
A. When the engine has run in for 800-1000km, a duly
check should be taken.
1). Replace the engine oil (the capacity of the engine oil is
1.8L)
2). The adjustment of the valve clearance inside cylinder
head is allowed
B. After finishing 800-1000km run-in, please activate
ordinary maintenance.
1). Check the spark plug, adjust the clearance and clean up
the carbon deposit.
2). Replace the engine oil
3). Tighten each fastener
4). Clean the air cleaner
Checking before Operations
In order to ensure safety, vehicles must be checked and
maintained on time.
Please make sure thorough inspection for the vehicle is finished
each time before you ride.
1、Engine oil level checking: Insufficient engine oil will cause
earlier abrasion, and damages.
2、Fuel level checking, tighten up the fuel tank cap, and check if
the fuel pipe is twisted.
3、Transmission chain checking, loosen chain will fall out of the
sprocket, severely worn out chain may break, insufficient lubrication
may cause the abrasion to the chain and sprocket, and if the chain is
getting too tight, then the transmission system will be suffering extra
burden, which in turn abase the chain or break the transmission.
4、Check the tire, to see if the tire is under abrasion, tire with
scratch or grooves abnormal should be replaced, the tire treads
depth should meets the legal regulation, moreover, tire pressure
inspection is also crucial. Both factors mentioned above is key to the
motorcycle performance and safety.
21