Basic Operation And Riding; Engine Startin; Run-In Of Engine - Mash Side 400 Mode D'emploi

V、Basic operation and riding
Before riding your motorcycle, please revise the safety
messages given in the first pages of this manual.
In this section, we will describe important notes and techniques
in order for you to safely ride this motorcycle. Please read this
manual thoroughly and spend some time practicing on your new
motorcycle. Pay attention on your safety and that of others.
Engine starting
Set the key of the ignition switch to "
Set the emergency stop switch to "
Ascertain the gear is in neutral position by checking the
neutral position lamp is lighted.
Ascertain the fuel level in the tank.
To start engine :
Start the engine by the electric cell motor. Each time you
push down the start button, it is recommended that you stop
pushing when firing sound of the engine combustion is heard and
the engine is fired and running. If the engine is not firing, please
stop pushing down the start button in 5 seconds, and wait for
more than 5 seconds before next start.
Slightly turn the throttle twist grip by about 1/8 turn but
never over 1/4 turn to increase intake air and restart the engine
again if the engine started but stalled during idling in cold
"position.
" position.
20
seasons, and keep the engine running at a higher speed so as to
warm up the engine for about 10 seconds or more.
Caution
The engine can only be started when the gear is in neutral
position or clutch is OFF. Otherwise accident may happen.
Unnecessary long time idle running (especially at a high
speed) may be harmful to the engine.
To stop engine running:
You can also stop the engine running by turn the ignition key to
" " position to cut off all electrical power.
If the start fails
If the engine can't be started, or the motorcycle is not moving,
the points below should be checked：
·If there is fuel in the tank
·If the motorcycle is properly operated according to the
instruction book shows
·If the fuse is melted
·If the engine start button is working properly
·If the battery is finished with power which cause the engine
start button not working, please try the kick start

Run-in of engine

Run-in of the engine is very important. Any operation without
run-in (or improper operation) will cause serious damages or failures
of function