Mash Side 400 Mode D'emploi page 26

Running in
Make 1000km running in at the speed of 6000rpm, this can
provide better longevity
Caution
Always start the vehicle from gear I, and make the
starting process as slow and carefully as possible.
During the riding, if there is any abnormal noise, please
contact the authorized distributors for inspection, and take
necessary step.
Keep the speed under the legal limit.
Looking at the terrain
＊ Watch your speed and control technique when you ride
on excessively flat, loose and rough surface, and keep an eye on
any potential hazards such as pits, water puddles, rocks, root
blocks, etc to avoid the risk of an accident.
＊ Driving forward out of ditch or muddy conditions, or up
a steep slope, could cause the motorcycle to up over backward.
If the mud is deep enough it will keep the wheels from turning.
Then, the motorcycle will rotate up and back around the axle very
quickly. When stuck in muddy conditions, do not remove the
implement or ballast weight. Always back out.
Avoid tipping over
＊ When starting the motorcycle on an uphill slope, shift
to as low a gear possible and reduce the engine speed to avoid
tipping over backward.
＊ Do not drive near the edge of a gully or steep embankment.
Avoid holes, ditches, etc. which may cause the motorcycle to tip over,
especially on hillsides or steep slopes.
＊ When operating the motorcycle on a slope, set the wheel
tread as wide as possible for maximum stability, reduce the engines
speed and avoid quick application of the brakes or sharp turns.
＊ Stay off hills and slopes which are too steep.
＊ When operating on slopes or rough uneven ground, it is
important to have as much distance as possible between the wheels.
Operate the motorcycle carefully at the lowest speed.
＊ When riding with poor visibility, e.g. riding at night, turn on
the headlight and slow down your speed to ensure safety.
Making turns
When you approach a turn, first slow down and smoothly turn the
handlebars to the direction you are going. Also, move your gravity to
the outer floor panel and tilt your upper body to the inner side of the
turn, which enables your control at the turn to be smoother and safer.
Warning
Do not make a sharp turn at high speed. Drive motorcycle
with care especially when turning at high speed.
Going downhill
Place your gravity as backward as possible and straighten
23