Controls Of The Eds 8000; Digital Display - HYDAC ELECTRONIC EDS 8000 Notice D'utilisation

6

5 Controls of the EDS 8000

E
Use the keys to select the next menu point, or alternatively to adjust the values.
• To scroll through the menu
• To increase the value
• Hold the key down to fast-scroll
through the parameter values

6 Digital display

Once the power supply has been switched on, the device briefly flashes "EdS", and then
begins to show the actual pressure.
To check the unit of measurement being used for the pressure indication, press
the right-hand key. Depending on the setting, bar, PSI or MPA will be shown.
The backlight changes colour according to the settings of the switch outputs and their switch
points, i.e. when the switch output is inactive or low-level, the relevant backlight is "green",
when the switch output is active or high-level, the relevant backlight is "red".
Backlight
for switching output 1
Status: 04.04.2018
2 keys (↓↑ and E) for adjusting the switch points, switch-back
points and additional functions
4-digit
digital display
LED backlight
to indicate switch points
(red = active / green = inactive)
E
Backlight
for switching output 2
HYDAC ELECTRONIC GMBH
• To select the menu point
E
• To confirm value
EDS 8000
Part No.: 669758