Maintenance And Replacement Parts - Fissler vitavit comfort Mode D'emploi

Maintenance and replacement parts

12. Maintenance and replacement parts
Please note
Replace parts that are subject to wear, such as the silicone gasket and other rubber parts, regularly after you have
cooked with it about 400 times, or after 2 years at the latest, with original Fissler replacement parts. Parts that show
visible damage (e.g. tears, discolorations or deformations) or that do not fit correctly must be replaced immediately.
Otherwise, the functioning and safety of your pressure cooker could be affected.
Information on replacing parts
Silicone gasket (Fig. A-20)
See Chapter 5.
Silicone membrane (Fig. A-22)
See Fig. V
Detach the control valve from the lid and remove the old silicone membrane. Place the new silicone membrane on
the plastic rod of the traffic light indicator and press the edge onto the metal push rod as far as the beginning of the
thread.
Molded valve seal (Fig. A-23)
See Fig. W
Detach the control valve from the lid and remove the old seal. Select Setting 2 on the control valve, because this will
make it easier to mount the seal. First place the new seal over the metal push rod, then press the other side all the
way up over the tappet. Make sure that the molded valve seal is tightly placed around the control valve.
Valve base seal (Fig. A-24)
See Fig. X
Detach the control valve from the lid and remove the old seal. Put the new seal in place and make sure that the seal
is perfectly flat on both sides of the lid.
O-ring for Euromatic (Fig. A-18)
See Fig. I
The o-ring is removed/mounted on the inside of the lid. Make sure that the ring lies totally in the groove provided
for it.
Euromatic (Fig. A-18)
To remove/mount the Euromatic, you must first remove the lid handle. This is very simple, as you only have to loosen
the screw on the inside of the lid. You can remove the Euromatic from the lid as soon as you have removed the
o-ring. For mounting, guide the new Euromatic without the o-ring through the lid so that the side with the white ball
is on the inside of the lid. Then you can mount the o-ring as described above.
45