Filling The Container With A Bag Support - WAGNER Plast Coat 830 Mode D'emploi

GB
commIssIonIng
AutOMAtIC SPRAy LANCe

• Open material tap (3, Fig. 16) on spray lance (material tap
facing to the rear), the mortar spraying machine is switched
on.
• If cellulose paste is pumped into the mortar hose, close ma-
terial tap (3, Fig. 16). (Material tap at 90° to spray lance)
• Fill coating material into the receptacle.
With mineral coating materials only fill the re-
ceptacle to half full.
• Position the spray lance over the bucket again.
• Open material tap (3, Fig. 16) on spray lance.
• As soon as coating material exits from spray lance,
close material tap (3, Fig. 16).
The mortar spraying machine is now full and ready.
6.7.1

FILLING tHe CONtAINeR WItH A BAG SuPPORt

(ACCeSSORy)
• Place bag on support such that the face end is facing the
opening.
• Cut sack open.
• Allow the coating material to flow into the receptacle.
Danger of crushing
Do not place hands under the roller.
• Place pressing roller on rear end of bag and roll forwards
several times over the bag.
With mineral coating materials only fill the re-
ceptacle to half full.
• Strip remaining coating material from sack opening with a
spatula.
48
1
3 2
PNeuMAtIC SPRAy LANCe

• Open material tap (1, Fig. 17) on spray lance. (Material tap at
90° to spray lance)
• If cellulose paste is pumped into the mortar hose, close ma-
terial tap (material tap facing to the rear).
• Set selector switch to "A".
• Fill coating material into the receptacle.
With mineral coating materials only fill the re-
ceptacle to half full.
• Position the spray lance over the bucket again.
• Set selector switch to "F".
• Open material tap (1, Fig. 17) on spray lance.
• As soon as coating material exits from spray lance, close ma-
terial tap (1, Fig. 17).
• Set selector switch to "A".
• Switch on compressor.
The mortar spraying machine is now full and ready.
6.7.1
FILLING tHe CONtAINeR WItH A BAG SuPPORt
(ACCeSSORy)
• Place bag on support such that the face end is facing the
opening.
• Cut sack open.
• Allow the coating material to flow into the receptacle.
Danger of crushing
Do not place hands under the roller.
• Place pressing roller on rear end of bag and roll forwards
several times over the bag.
With mineral coating materials only fill the re-
ceptacle to half full.
• Strip remaining coating material from sack opening with a
spatula.
Plast Coat 830
1