Preparing The Mortar Spraying Machine - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
AutOMAtIC SPRAy LANCe
6.7

PRePARING tHe MORtAR SPRAyING MACHINe

(FIG. 15)
Recommended sliding means for the mortar hose
Water is not sufficient as a sliding means.
Danger of clogging!
Use cellulose paste (e.g. Metylan wallpaper
paste, art no. 2312136)

1 2 3
• Fill 2–3 l cellulose paste into the container.
• Connect the mortar spraying machine to the mains supply.
The operation light (1) shows operational readiness.
Risk of injury from escaping material.
Before switching on, always check that the
material tap on the spray lance is closed.
Close material tap whenever stopping
work.
• Set selector switch (2) to "A".
• Set delivery volume controller (3) to „ 3".
Do not bend the mortar hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
• Hold spray lance over an empty bucket.
PNeuMAtIC SPRAy LANCe
6.7
PRePARING tHe MORtAR SPRAyING MACHINe
(FIG. 15)
Recommended sliding means for the mortar hose
Water is not sufficient as a sliding means.
Danger of clogging!
Use cellulose paste (e.g. Metylan wallpaper
paste, art no. 2312136)

1 2 3
• Fill 2–3 l cellulose paste into the container.
• Connect the mortar spraying machine to the mains supply.
The operation light (1) shows operational readiness.
Risk of injury from escaping material.
Before switching on, always check that the
material tap on the spray lance is closed.
Close material tap whenever stopping
work.
• Set selector switch (2) to "A".
• Set delivery volume controller (3) to „ 3".
• Switch off compressor.
Do not bend the mortar hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
• Hold spray lance over an empty bucket.
• Set selector switch to "F".
GB
commIssIonIng
47