Introduction To Working With The; Function Of The; Plastcoat 430; Processible Coating Materials - WAGNER Plast Coat 430 Mode D'emploi

Plast Coat 430
2
INTRODUCTION TO WORKING WITH
THE MORTAR SPRAYING MACHINE

PLASTCOAT 430

The suction pump PlastCoat 430 is conceived for using and
bucket.
tion tube into the material bucket.
The machine is not designed for use as a cleaning device.
2.1
FUNCTION OF THE MORTAR SPRAYING MACHINE
PLASTCOAT 430
The coating material is fed through the suction effect of the
screw pump. The suction effect causes the coating material
to enter the eccentric screw pump. This pump builds up the
pressure required for transportation through the mortar hose.
The compressed air required for atomisation is supplied at the
and off using the electric control. This can also be used to con-
2.2

PROCESSIBLE COATING MATERIALS

All the coating materials must be suitable for machine process-
ing. Refer to the product data sheet of the coating material to
be processed.
3

TECHNICAL DATA

Voltage:
-
Fusing:
Motor output P :
1
Max. operating pressure:
Max. granular size:
Dimensions L x W x H:
Weight (PlastCoat 430):
Weight (
Degree of protection:
Max. sound pressure level:
Atomizing air connection:
Max. atomizing air pressure:
Minimum required compressed
air volume:
Max. mortar hose length:
* Place of measurement: 1 m distance from unit and 1.60 m
above reverberant floor.
PlastCoat 430
230 V~, 50 Hz
16 A time-lag
5 m long, 3 x 1.5 mm
1.8 kW
12 l/min
40 bar
K3 mm
700 x 600 x 1050 mm
38 kg
): 2.1 kg
2.5 bar
IP 55
70 dB (A)*
Rapid action coupling
DN 7.2 mm
10 bar
280 l/min
30 m (and 2.5 m hose
whip)
20 m
GB
INTRODUCTION
2
35