Transportation; Moving; Transport Using A Crane; Transportation In Vehicle - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
5

tRANSPORtAtION

5.1

MOVING

Roll up mains cable and remove hose.
Handles (fig. 4.1) are folded upwards.
Raise the PC 830 by the handles to facilitate pulling or push-
ing by hand.
To fold the handles inwards, turn them and then push down-
wards.

Make sure that 2 people are available to
carry the device on stairs.
5.2

tRANSPORt uSING A CRANe

For attaching points for the straps or rope (not wire cable) see
figure.
5.3

tRANSPORtAtION IN VeHICLe

Secure the unit in the vehicle by means of suitable fasteners.
6

COMMISSIONING

6.1

INStALLAtION LOCAtION

1
Position mortar spraying machine in a level position to pre-
vent it from sliding away.
6.1.1
CONNeCtION tO MAINS POWeR SuPPLy/
exteNSION CABLe
Connection to the mains network only via a special feed-
ing point, for example via a distribution board for con-
struction sites, with residual current protective device
with INF ≤ 30 mA.
• Before connecting the unit to the mains supply, ensure that
the line voltage matches that specified on the rating plate.
6.2
INItIAL StARtING-uP
6.2.1

SCOPe OF SuPPLy

The machine is supplied by the manufacturer in the following
individual components:
• Complete basic machine comprising drive unit, control unit,
receptacle and transport frame with wheels
• Stator
• Tool : Special key
• Hose package
• Spray lance
• Pump sliding means
To avoid material residues leaking from the
machine, clean the device in advance or lock
the mortar connection.
Lay the device supply cable so that there is no
danger of stumbling.
Protect against damage, for example against
being driven over.
Min. wire cross-section 3 x 1.5 mm
extension cable completely. Ensure that the
coupling pieces and plugs are free of dam-
age.
GB
transportatIon
. Unroll the
2
43