Introduction To Working With The Mortar Spraying Machine Plastcoat1030; Function Of The Mortar Spraying Machine Plastcoat 1030; Processible Coating Materials; Technical Data - WAGNER PLASTCOAT 1030 Mode D'emploi

Plast Coat 1030
2
INTRODUCTION TO WORKING WITH
THE MORTAR SPRAYING MACHINE
PLASTCOAT1030
The suction pump PlastCoat 1030 is conceived for using and
processing ready mixed mineral coating materials.
The machine is not designed for use as a cleaning device.
2.1
FUNCTION OF THE MORTAR SPRAYING MACHINE
PLASTCOAT 1030
The coating material is supplied by means of the container.
The spiral conveyor feeds the coating material to the eccen-
tric screw pump. The suction effect causes the coating materi-
al to enter the eccentric screw pump. This pump builds up the
pressure required for transportation through the mortar hose.
The compressed air required for atomisation is supplied at the
spray lance. The mortar spraying machine can be switched on
and off using the electric control. This can also be used to con-
trol the delivery volume.
A soft even spray pattern can be achieved by means of the
smoothly regulated convey capacity of the coating material.
2.2

PROCESSIBLE COATING MATERIALS

• Thermal insulation composite system bonding agent
(mineral and artificial resin systems)
• Artificial resin plasters up to 6 mm granular size
• Silicate plasters up to 6 mm granular size
• Silicone resin plasters up to 6 mm granular size
• Mineral final coats up to 6 mm granular size
• Lightweight plaster systems up to 6 mm granular size
• Scraped stucco up to 6 mm granular size
• Thermal insulation plasters
• Restoration plaster
• Porous concrete coating
• Quartz plastic
• Roof coatings
• Fire protection coatings
• Mineral sealing sludges
• Bitumen emulsions
• Armoring filler
• Liquid wood-chip wall paper
• Casement grouting mortar
• Artificial resin rendering base
• Wash primer
• Filling paint, also fibrous
• Elastic coating
• Acoustic plaster, artificial resin bonded
• Fillers, artificial resin bonded
All the coating materials must be suitable for machine pro-
cessing. Refer to the product data sheet of the coating mate-
rial to be processed.
Use other coating materials only after agreement with the
manufacturer or the WAGNER application technology service.
3

TECHNICAL DATA

Voltage:
Fusing:
Device supply cable:
Motor output P :
1
Max. convey capacity (water):
Max. operating pressure:
Max. granular size:
Dimensions L x W x H:
Container capacity:
Weight (PlastCoat 1030):
Weight (Spray lance):
Max. tyre pressure:
Degree of protection:
Max. sound pressure level:
Atomizing air connection:
Max. atomizing air pressure:
Minimum required compressed
air volume:
Max. mortar hose length:
Max. delivery height:
* Place of measurement: 1 m distance from unit and 1.60 m
above reverberant floor.
GB
INTRODUCTION
PlastCoat 1030
230 V~, 50/60 Hz
16 A time-lag
5 m long, 3 x 2.5 mm 2
2.3 kW
10, 15, 20 l/min
(depending on the rotor/
stator)
40 bar
K6 mm
1150 x 520 x 610 mm
50 l
59 kg
2.1 kg
2.5 bar
IP 54
70 dB (A)*
Rapid action coupling
DN 7.2 mm
10 bar
320 l/min
40 m (and 2.5 m hose
whip)
20 m
33