Introduction To Working With The Mortar; Operation Of The Mortar; What Materials Can Be Sprayed; Technical Data - WAGNER PlastCoat PC15 Mode D'emploi

Plast Coat 15
EDITION 09 /2004
2
INTRODUCTION TO WORKING WITH
THE MORTAR SPRAYING MACHINE
PLASTCOAT 15
The mortar spraying machine PlastCoat 15 can be combined
with continuous flow, gravitation, compulsory or pan mixers
or the processing of mineral coating materials.
The container suction system (accessory) can be used to suck
directly from a container.
2.1

OPERATION OF THE MORTAR

The coating material is supplied by means of the receptacle.
The spiral conveyor feeds the coating material to the eccen-
tric screw pump. This pump builds up the pressure required
for the transport through the mortar hose.The compressed air
necessary for atomizing the material is supplied to the spray
lance. The mortar spraying machine can be switched on and
off using the electrical remote control. The continuously adju-
stable feed rate of the coating material can be used to create a
soft, even spraying pattern.
2.2

WHAT MATERIALS CAN BE SPRAYED?

• Heat insulating composite system adhesive (mineral and
synthetic resin systems)
• Synthetic resin plasters up to grain size of 4 mm
• Silicate plasters up to grain size 4
• Silicate resin plasters up to grain size 4
• Mineral final coat plaster up to grain size 4
• Light plaster systems up to grain size 4
• Scraped rendering up to grain size 4
• Insulation plaster
• Renovating plaster
• Foam mortar coating
• Quartz plastic
• Roof coatings
• Flameproof coatings
• Mineral sealing slurries
• Bitumen emulsions
• Reinforcing filler
• Liquid wood chip
• Frame sealing mortar
• Synthetic resin rendering base
• Primer
• Filling paints, incl. fiber containing
• Elastic coatings
• Acoustic plaster, synthetic resin bonded
• Filler, synthetic resin bonded
INTRODUCTION TO WORKING / TECHNICAL DATA
All coating materials should be suitable for applying using
machines. See product data sheet for the coating material to
be used.
Only use other materials after prior consultation with the ma-
nufacturer or WAGNER application technology dept.
3

TECHNICAL DATA

Voltage:
Fuse protection:
Device mains cable:
Socket on the control unit-
max. load:
Motor output P :
1
Max. feed rate (water):
Max. operating pressure:
Max. grain size:
Measurements L x W x H:
Receptacle capacity:
Weight:
Tire pressure, max.:
Protective system:
Max. sound pressure level:
Atomization air connection:
Max. atomization air
pressure:
Required volume of
compressed air, min:
Texture nozzle:
Mortar hose:
* Measuring point: At a distance of 1 m to the side of the
unit and at a height of 1.60 m above floor, reverberant floor.
GB
PlastCoat 15
230 V ~, 50 Hz
16 A slow-blow
6 m long, 3 x 1.5 mm 2
450 watts
1.5 kW
11 l / min
40 bar
K 4 mm
1180 x 530 x 660 mm
60 l
70 kg
2 bar
IP 54
70 dB (A)*
Rapid action coupling
DN 7 mm
10 bar
220 l/min
8 mm (standard)
DN 27 mm,
10 m (standard)
37