Drive; Compressor (Accessory); Mortar Hose For Pneumatic Spray Lance; Pneumatic Spray Lance - WAGNER Plast Coat 830 Mode D'emploi

Plast Coat 830
If the selector switch is in the "F" position when
the mains plug is plugged in, the machine will not
switch on.
Briefly move selector switch to "A" and then back
to "F" to switch on the machine.
eMeRGeNCy StOP switch
When the EMERGENCY STOP switch is pressed, the PC 830 is
switched off immediately.
Turn the EMERGENCY STOP switch in order to release it again.
The machine remains switched off after release. To switch it on
again, the selector switch must be briefly set to "A" and then
to "F".
4.2

DRIVe

When an overload occurs, the mortar spraying machine
switches off automatically (red indicator light lights up).
Move selector switch (Fig. 3, 2) to "A" and disconnect mains
plug. Set delivery volume controller (Fig. 3, 1) to „ 0".
Wait around 5 minutes, then plug the mortar spraying machine
back in and switch on. Set the delivery volume required.
The drive unit heats up during operation. This
is normal and not a sign of malfunction.
4.3

COMPReSSOR (ACCeSSORy)

VkM 592 intake volume 590 l/min
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
4.4

MORtAR HOSe FOR PNeuMAtIC SPRAy LANCe

1 Material connection mortar spraying machine
2 Atomizing air connection compressed air supply
3 Material connection spray lance
4 Mortar hose
5 Atomizing air connection spray lance
1
5 4
4.5

PNeuMAtIC SPRAy LANCe

1 Atomizing air connection
2 Texture tip
3 Combined material and air tap
Open: material tap at 90° to spray lance
Closed: material tap facing to the rear
4 Material connection
4
1
Various texture tips can be used in the spray lance. The tip size
depends on the granular size of the coating material and the
desired spray pattern.
overvIew
2
3
3
GB
2
41