Lubrication Points - Grillo CLIMBER 7.15 Manuel D'utilisation

LUBRICATION POINTS

Grease the belt tightener and the forward lever via the appropriate grease nipples (fig. 16) and the blade shaft too (fig. 20).
CAUSE
– Battery not supplying power
Dashboard ON, but starter motor does not turn over with key in "AVV" (ON) pos.
– Battery not supplying enough power
– Start-up go-ahead not given
– Carburetion problems
– Deposits or dirt in fuel
– No petrol flow
– Fault in ignition system
Climber Series 7/ Translation of the original instructions
TROUBLE-SHOOTING
PROBLEM
Dashboard OFF with key in "AVV." (ON) pos.
Difficult starting or irregular running of engine
Starter motor turns over but engine does not start
REMEDY
– Check connecting cables
– Recharge battery
– Change the fuse
– Recharge battery
– Travel lever in stop position
– Disengage blades
– Sit in the driver's seat
– Check the three safety sensors (seat – blades
engagement - feed lever)
– Clean or change the air filter
– Adjust the carburettor
instructions)
– Empty the tank and use fresh petrol
– Check and change the petrol filter if necessary
– Check that the choke has been activated (if engine is
cold)
– Check petrol level in tank
– Check wiring of carburettor opening control
– Check petrol filter (and change if necessary)
- Check that the vent on the tank cap is not blocked
– Check that the caps of the sparkplugs are correctly
fastened
– Check that the electrodes are clean and at the correct
distance apart.
11
(follow engine manual