Technical Specifications; Instructions For Use - Grillo CLIMBER 7.15 Manuel D'utilisation

ENGINE:
CL7.15 – Loncin LC1-P92F 15, OHV, 12 HP (9,2 kW) 452 cc, single-cylinder petrol engine.
CL7.18 – B&S VANGUARD 7180 INTEK OHV 15,2 HP 656 cc, twin-cylinder, internal combustion, 4-stroke series.
STARTING SYSTEM: electric with battery 12V.
GEARBOX: hydrostatic transmission.
DIFFERENTIAL: with locking device.
CLUTCH: for PTO with electromagnetic clutch.
GROUND SPEED: continuously variable from 0 to 10 km/h + reverse speed from 0 to 6 km/h.
TYRES: front: 13×5.00-6; rear: 16x 6.50-8.
BRAKE: front emergency brake; rear parking brake.
OPERATOR SEAT: sprung and adjustable, equipped with roll bar.
CUTTING DECK: side/rear discharge.
CUTTING SYSTEM: single rotating blade.
CUTTING WIDTH: 850 mm
BLADE SPEED: 76 m/sec
CUTTING HEIGHT: from 35 mm (±1.3'') to 85 mm (±3.3'') with 6 different cutting positions and 1 travel position.
WORK CAPACITY: 5000 m
STEERING RADIUS: 450 mm.
FUEL TANK: 7 litres RESERVE: 1 litres
STANDARD FEATURE: tow bar, front headlight.
SIZES: W956xL1895xH980mm.
WEIGHT: 225 kg – CL7.13 /

PUTTING THE MACHINE INTO SERVICE
1)
Check that the machine has not been damaged in transit.
2)
Check the oil levels of the engine and hydrostatic transmission.
3)
Check the tyre pressure:
4)
1 BAR front wheels 13×5.00-6
5)
1.2 BAR rear wheels 16×6.50-8.
6)
Check the battery voltage; it must be at least 12 Volts. Charge if necessary.
7)
IMPORTANT!!! During assembly take care not to reverse the polarity of the battery.
8)
Fix the steering wheel taking care the key is properly inserted and the screw is tight enough (tightening torque 2 KgF.m
[20 N.m]).
9)
Fit the muffler, the rear bumper and the roll bar.
RUNNING IN – CAUTION!!
Change the engine oil and filter after the first 5 working hours.
Check that there are no oil leaks or slack screws, especially those which fix the blade and the steering.
BEFORE STARTING UP THE ENGINE
Before starting up the engine, always check that:
– the travel lever is in the idle position (fig. 3);
– the engine oil level is correct (fig. 4);
– the engine cooling intake grilles are clean (fig. 7);
– air filter is clean (fig. 8 – 8A).
– the mowing deck is clean;
– the hydraulic motor fins are clean (fig. 5);
– the blades are sharp and firmly fastened in place;
– the screw in the centre of the blade hub is safety tightened (no. 3, fig. 9)
– the oil in the hydraulic axle is at the correct level (fig. 5); the correct level is 12 mm underneath the bottom of the tank (fig.
6);
Fill the fuel tank using a funnel with very fine filter (no. 4, fig. 10).
Adjust the seat by using the lever fig. 11.
Climber Series 7/ Translation of the original instructions

TECHNICAL SPECIFICATIONS

2 /h (indicative) – CL7.13; 6.000 m2/h (indicative) – CL7.18.
245 kg – CL7.18


INSTRUCTIONS FOR USE

7