Technical Specifications; Putting The Machine Into Service; Instructions For Use - Grillo Climber 710 Manuel D'utilisation

RECOMMENDED LIST OF SPARE PARTS TO BE KEPT IN STORE
2 x mowing blades
2 x blade screws
2 x blade screw nuts
1 x set of belts
1 x air filter for engine
1 x oil filter for engine
1 x throttle cable
2 x wiring system fuses

TECHNICAL SPECIFICATIONS

ENGINE:
BRIGGS & STRATTON INTEK 344, 4-stroke OHV petrol, 13 HP,
with oil pump, oil filter and cast iron cylinder.
HOURLY CONSUMPTION:
STARTING SYSTEM:
GEARBOX:
hydrostatic transmission.
CLUTCH:
for PTO with electromagnetic clutch.
GROUND SPEED:
TYRES (GARDEN wheels) front:
BRAKE:
rear parking disc brake.
OPERATOR SEAT:
CUTTING DECK:
side/rear discharge.
CUTTING SYSTEM:
CUTTING WIDTH:
BLADE SPEED:
74 m/sec.
CUTTING HEIGTH:
WORK CAPACITY:
STEERING RADIUS:
FUEL TANK:
7 lt.
IMPLEMENTS:
towing bar as a standard, front headlight
SIZES:
Width: 900 mm - Length: 1895 mm - Height: 975 mm
WEIGHT:
215 kg.

PUTTING THE MACHINE INTO SERVICE

1) Check that the machine has not been damaged in transit.
2) Check the oil levels of the engine, hydrostatic transmission and final drive.
3) Check the tyre pressure:
1 BAR front wheels 13 x 5.00-6
1.2 BAR rear wheels 16 x 7.50-8.
4) Check the battery voltage; it must be at least 12,5 Volts. Charge if necessary.
IMPORTANT!!! During assembly take care not to reverse the polarity of the battery.
5) Fix the steering wheel taking care the key is properly inserted and the screw is tight enough
(tightening torque 2 KgF.m [20 N.m]).
RUNNING IN - CAUTION!!
Change the engine oil and filter after the first 5 working hours.
Check that there are no oil leaks or slack screws, especially those which fix the blade and the steering.

INSTRUCTIONS FOR USE

Before starting up the engine, always check that:
Climber 7.10 / Translation of the original instructions
3 lt/h.
electric, with battery 12V.
from 0 to 9 km/h with continuous variation and reverse from 0 to 4 km/h.
13x5.00-6;
sprung und adjustable
single rotating blade with floating terminals.
780 mm.
from 35 mm to 85 mm, 6 cutting positions and 1 for travelling.
2
4500 m /h (indicative).
450 mm.
RESERVE TANK:
INSTRUCTIONS FOR USE
rear:
16x 7.50-8.
.
1,5 lt.
.
.
7