Table des Matières
Publicité
Alarm
code
Connection to ECV failed.
349
Connection to MM0X failed.
350
Fertilizer adjustment required.
351
MICROSEM adjustment required.
352
Target value of fertilizer changed due to new
353
adjustment value
Target value of MICROSEM changed due to new
354
adjustment value.
Fertilizer hopper empty.
355
Machine code invalid.
356
The speed is too high: MICROSEM motor has
reached the upper limit of turning.
357
All rows are deactivated.
358
MICROSEM motor blocked.
359
Encoder power supply fault.
360
No Fileserver found.
361
Connection to speed sensor switch failed.
362
Voltage on power supply for speed sensor
363
switch to loo.
No signal from radar sensor.
364
No signal from wheel sensor.
365
TC-GEO enabled, but the planter is set to seed
366
spacing mode.
Motor rpm change more than 10% over the target.
367
ALARMS LISTING
Cause
1- Check the connection cables of ECV.
2- Check the terminator connection on the last ECV.
3- Check the switches on the ECV.
4- Check that there are enough ECV connected to the corresponding machine configuration.
5- Do/Start a manual software update of the ECV.
6- Replace ECV.
7- Replace main ECU.
1- Check the connection cables of MM0X.
2- Check that there is the correct MM0X connected to the corresponding machine
configuration.
3- Do/Start a manual software update of the MM0X.
4- Replace MM0X.
5- Replace main ECU.
1- Do a fertilizer adjustment.
1- Do a MICROSEM adjustment.
1- Check fertilizer target value.
1- Check MICROSEM target value.
1- Check fertilizer hopper.
2- Check hopper level sensor connection.
3- Check hopper level sensor.
4- Check machine configuration.
5- Replace main ECU.
1- Enter a correct machine code.
1- Drive slower.
2- Check correct value for speed signal (Imp/100m).
3- Do a 100 m justification.
4- Check speed sensor.
1- Activate at least one row.
1- Check the ease of rotation of the MICROSEM motor.
2- Check encoder wires between seed motor and MICROSEM motor ECU.
3- Replace MICROSEM motor ECU.
1- Check encoder cable, possible short circuit.
2- Replace MICROSEM motor ECU.
3- Replace MICROSEM motor (encoder fault).
1- Check if there is a ISOBUS Fileserver connected to / present on the ISOBUS.
1- Check connection to the speed sensor switch.
2- Do/Start a manual software update of the speed sensor switch.
3- Replace speed sensor switch.
1- Check the voltage of the power of the speed sensor switch.
2- Check all fuses.
3- Replace speed sensor switch.
1- Check the connection of the radar sensor.
2- Check correct value for speed signal of the radar sensor (Imp/100m).
3- Do a 100 m adjustment of the radar sensor.
4- Check radar sensor.
5- Replace radar sensor.
6- Replace speed sensor switch.
1- Check the connection of the wheel sensor.
2- Check correct value for speed signal of the wheel sensor (Imp/100m).
3- Do a 100 m adjustment of the wheel sensor.
4- Check wheel sensor.
5- Replace wheel sensor.
6- Replace speed sensor switch.
1- Set the planter to UNIFORM.
1- Check the motor.
2- Replace the motor.
To do
90
Publicité
Table des Matières
