Enabling And Disabling Auto Impedance - Boston Scientific Vercise DBS Mode D'emploi

Enabling and Disabling Auto Impedance

The Auto Impedance feature automatically measures the impedances of the Vercise™
DBS System when you enter the Programming screen. The Auto Impedance feature will
be disabled whenever the Bionic Navigator software is exited.
If the Auto Impedance feature is disabled, the contacts on the Programming screen will
display an [X] until you measure impedances. If the Auto Impedance feature is enabled,
no [X]'s will appear on the Programming screen (unless impedances are over 4500 Ω for
a specific contact).
To enable the Auto Impedance feature:
1 Click
2 Select Enable Auto Impedance from the drop‑down menu.
To disable the Auto Impedance feature:
1
Click
2 Select Disable Auto Impedance from the drop‑down menu.
from the toolbar on any screen.
from the toolbar on any screen.
Using Additional Tools
Vercise™ DBS Programming Manual
91053785-17 65 of 1705