Specifications; Configuration - TLV PowerTrap GP14-B Manuel D'utilisation

Specifications

CAUTION
CAUTION
Refer to the product nameplate for detailed specifications.
Nominal Diameter
Maximum Allowable Pressure*
Maximum Operating Pressure
Valve No.**
* Maximum allowable pressure (PMA) and maximum allowable temperature (TMA) are PRESSURE
SHELL DESIGN CONDITIONS, NOT OPERATING CONDITIONS.
** Valve No. is displayed for products with options. This item is omitted from the nameplate when
there are no options.
GP14-B (other than below)
Motive Medium
Pressure Range
GP14-B (Cast Iron in Europe)
Maximum Allowable
Back Pressure

Configuration

Body
Float
Install properly and DO NOT use this product outside the recommended
operating pressure, temperature and other specification ranges.
Improper use may result in such hazards as damage to the product or
malfunctions which may lead to serious accidents. Local regulations may
restrict the use of this product to below the conditions quoted.
Use only under conditions in which no freeze-up will occur. Freezing may
damage the product, leading to fluid discharge, which may cause burns
or other injury.
0.05 MPa / 0.5 bar / 7 psi less than motive medium pressure used
(but not to exceed 1.05 MPaG / 10.5 barg / 150 psig)
Exhaust Outlet
Motive Medium Inlet
Pumped Medium
Inlet
Snap-action Unit
Cover
Pumped Medium
Outlet
Lever Unit
Cover Gasket
Model
Serial Number
Maximum Allowable Temperature* TMA
Maximum Operating Temperature TMO
0.03 - 1.4 MPaG
0.03 - 1.3 MPaG
Exhaust Outlet
Plug
Motive
Medium Inlet
Intake
Valve Unit
Exhaust Valve Unit
— 7 —
0.3 - 14 barg 5 - 200 psig
0.3 - 13 barg 5 - 185 psig
Exhaust Outlet
Motive Medium Inlet
Nameplate
Pumped Medium
Inlet
Pumped Medium
Outlet
Cover Bolt