Removing/Reinstalling The Intake Valve And Intake Valve Seat (Motive Medium) - TLV PowerTrap GP14-B Manuel D'utilisation

6. Removing/Reinstalling the Intake Valve and Intake Valve Seat
(Motive Medium)
The following procedure can be used to remove and replace the intake (motive medium)
valve without first removing the cover of the PowerTrap.
Part
･ Using a 38 mm (1
Plug /
Plug Gasket
loosen the plug.
･ Finish loosening by hand, and remove
the plug and plug gasket.
･ Using needle-nose pliers, remove the
Intake Valve
intake valve and screen.
(motive medium) /
Screen
･ Using a 17 mm (
Intake Valve Seat
(motive medium) /
with an extension bar, loosen the
Valve Seat valve seat.
･ Using needle-nose pliers, grasp and
Gasket
remove the valve seat.
･ Using a needle tool, dislocate the
valve gasket, then catch and lift it out
with either the needle or needle-nose
pliers.
NOTE: It is possible to remove
and replace the intake
valve (motive medium)
without first removing the
cover of the PowerTrap
(see instructions above).
Disassembly
/
") socket wrench,
1 2
/ ") socket wrench
21 32
— 29 —
Reassembly
･ Coat plug threads with anti-seize
and reinstall plug and plug gasket.
･ Tighten to a torque of 160 N·m
(115 lbf·ft).
･ Replace the screen and valve
with new, and assemble in
reverse order of disassembly.
･ Make sure you have removed the
old valve gasket. Insert and
position a new gasket.
･ Coat threads of valve seat with
anti-seize.
･ Using needle-nose pliers, insert
the valve seat.
･ Tighten to a torque of 160 N·m
(115 lbf·ft).
(1 N·m ≈ 10 kg·cm)
Plug
Plug Gasket
Intake Valve
(Motive Medium)
Screen
Intake Valve Seat
(Motive Medium)
Valve Seat Gasket
Intake Valve
Unit