Installation; Open System Piping (Steam System Example) - TLV PowerTrap GP14-B Manuel D'utilisation

Installation

CAUTION
CAUTION
CAUTION
CAUTION
CAUTION

Open System Piping (Steam System Example)

Pm
Rm
Sm
Sv
Se
Sf
Ve
Km
Power
Trap
NOTE: This sketch is for explanation purposes only and is not intended as an installation design.
Necessity of installing a condensate receiver
It is necessary for storing condensate during pumping.
Condensate cannot enter the PowerTrap while condensate is being pumped.
Install properly and DO NOT use this product outside the recommended
operating pressure, temperature and other specification ranges.
Improper use may result in such hazards as damage to the product or
malfunctions which may lead to serious accidents. Local regulations may
restrict the use of this product to below the conditions quoted.
Use hoisting equipment for heavy objects (weighing approximately
20 kg (44 lb) or more). Failure to do so may result in back strain or other
injury if the object should fall.
Take measures to prevent people from coming into direct contact with
product outlets. Failure to do so may result in burns or other injury from
the discharge of fluids.
Do not use excessive force when connecting threaded pipes to the
product. Over-tightening may cause breakage leading to fluid discharge,
which may cause burns or other injury.
Use only under conditions in which no water hammer will occur. The
impact of water hammer may damage the product, leading to fluid
discharge, which may cause burns or other injury.
Q
St
Vm
Vb
Vi
Ci
Ki
Si
Co Vo
PowerTrap
Pb
So
— 8 —
Pi
Sr