salmson LRE Instructions De Montage Et De Mise En Service page 51

ENGLISH
7.4.4 Blocking the pump
Setting of the control systems and parameters can be blocked
against unauthorised access.
When blocking is active only faults can be acknowledged by
pressing the tuning button.
Blocking can be activated or deactivated.
17
7.4.5 Fault menu
18
LC display
LC display
By setting the corresponding DIP switch in the converter termi-
x
nal box. The following menu then appears:
When the DIP switch is active no other settings
CAUTION!
can be made, but faults can still be acknowled-
ged.
The current condition is displayed statically.
Switching blocking on/off:
Press button. The new setting blinks.
Press acknowledge button to store the new setting.
To exit the menu the DIP switch must be reset (see above). The status dis-
play with or without key appears.
In the event of a fault condition the relevant fault is indicated by
E = error and the code No.
For the code Nos. and their meanings see table (section 11.6).
45
Setting
Setting