salmson LRE Instructions De Montage Et De Mise En Service page 48

ENGLISH
10
11
LC display
Enabling / disabling the external pressure set value
Possible settings: 0-10V; 2-10V; 0-20mA; 4-20mA.
The signal is present at terminal IN2 in the terminal box.
CAUTION: Do not confuse with the ACTUAL value signal on terminal IN1!
The setting involves 3 steps.
1. Enable / disable input IN2 in this menu
X
2. V / mA in menu
11
3. Select range of values in next menu
Press button. The new setting blinks.
Press acknowledge button to store the new setting.
The display jumps to the next menu:
X
IN2 = on -> Menu
11
X
IN2 = off -> Menu
13
Note:
X
If IN2 is active, menu 4
can no longer be selected
Setting the signal type for the set pressure value (step 2).
The menu comes after the above menu
Selecting the signal type: [V (Volt) / mA (Milliampere)]:
Press tuning button to toggle between V (Volt) and
mA (milliampere).
The new setting blinks.
Press acknowledge button to store the new setting.
X
Menu is displayed.
12
X
If IN2 is active, menu 4
can no longer be selected.
42
Setting
X
.
10
X
.
12
X.
11