salmson LRE Instructions De Montage Et De Mise En Service page 50

ENGLISH
14
15
The display returns to the basic setting 2
In the event of a fault, the fault menu 2
PLR/LON active
16
LC display
X
X
is displayed instead of the basic setting
Sending LON service signal.
Note:
X
This menu is only displayed if IF module LON is plugged in!
14
Press button to display the next menu (
Switching function on/off:
Press button. The new setting blinks.
Press acknowledge button to store the new setting.
X X
or 2
Menu 15 is displayed.
If the condition "on" is confirmed, a single service signal is sent to the
building management system.
MA / SL setting.
Note:
X
This menu 15 is only displayed in double pump mode!
Programming is only possible on the MA pump.
No settings can be made on the SL. Changing the master - slave allocation is
only possible on the master.
The current setting is displayed.
If the master - slave allocation was wrongly selected when starting up
for the first time (recommendation: master in flow direction on left with
connected pressure sensor, slave in flow direction on right (see FIG. 1a),
the setting can be corrected in this menu.
Changing MA / SL setting:
Press button. The new setting blinks.
Press acknowledge button to store the new setting.
.
Automatically activated with plugged in LON module and signal from
the external building automation system.
A symbol in the form of a double arrow appears in the display:
The following settings are possible:
Operation menu >Addition or main/reserve mode
Service menu > Display orientation, IN1 selection, error matrix, LON-ID
(only with LON module), change MA/SL, dPS on/off
44
Setting
X X
or 2
).
15
X
.
18